The cdc_fifo module transfers data between two clock domains: a write clock domain and a read clock domain. The module includes a dual-ported RAM(dpram) for storing data, along with logic for handling read and write operations(cdc_fifo_read_state and cdc_fifo-write-state). synchronizers(synchronizer) and binary/gray converters(binary_to_gray and gray_to_binary) ensure proper synchronization between two clock domains.
Hold write_reset and read_reset LOW while running the clock for a bit to reset, then raise to initialize the module.
writing to the fifo: Prepare your data on the 4-bit write_data bus, ensure the full state is low and then raise write_increment for 1 cycle of write_clock to write data into the FIFO memory.
Reading from the fifo: The FIFO will present the current output on the read_data bus. If empty is low, this output should be valid and you can acknowledge receive of this vallue by raising read_increment for 1 cycle of read_clock.
NO external hardware is used.
| # | Input | Output | Bidirectional |
|---|---|---|---|
| 0 | write_clock | empty | write_reset |
| 1 | write_increment | full | read_reset |
| 2 | read_clock | ||
| 3 | read_increment | ||
| 4 | write_data0 | read_data0 | |
| 5 | write_data1 | read-data1 | |
| 6 | write_data2 | read_data2 | |
| 7 | write_data3 | read_data3 |